Introduction
Using alarm systems will ensure your safety, but sometimes problems happen and you do not know how to fix them. For example, sometimes detectors may start ringing and not go off. Also, you may move into a new house where there are alarm systems but you don’t know the alarm code? Reset alarm system can be a good solution, stay with us to know about it.
When you need to reset alarm system?
Sometimes you may find it necessary to reset your home alarm system. This can happen for different reasons. Reset alarm system might be needed when a power outage or brownout occurs. Also, when you need to change the alarm backup battery or when you purchase a new home and you do not know the alarm system password you will need to reset the alarm system.
If you contact the alarm company in such cases, the alarm system company will not reset the alarm system unless you purchase a service or monitoring contract. This is often a costly proposal. So, knowing How to reset the alarm system without code is a good way to solve these problems.
How do you reset alarm system without the code?
Reset alarm system means returning the alarm system to its original unprogrammed state, removing all programming from the system, and returning it to its default state. There are some steps to reset alarm system without the code:
- Find the System or System Status button on your home alarm keypad. Press the button twice quickly to mute the AC power alarm.
- Wait until AC power is restored to your home. Remove the system backup battery from the alarm keypad.
- Lift the breaker box cover and find the breaker that controls your home alarm system. Move the breaker to the “Off” position completely; Return the breaker to the “On” position after five minutes.
- Replace the backup battery of the main alarm keypad. Insert a new battery, Note that most home alarm manufacturers recommend replacing the backup battery every 12 to 15 months. Insert a new battery whenever you get a low battery message on the panel.
- Enter your user code on the main alarm keypad; press the “Stop” button. Re-enter your user code and press the “Off” button a second time to reset the alarm system.
What you can do if have forgotten your alarm code?
If you move to a new home and don’t know the code for your old alert system, you have the following options:
- Try a “default code”
- Reset your alarm panel
- Contact the old owner of the property
- contact alarm center
All alert systems have a “default” code. The code when the system was shipped and the manufacturer code depends on the manufacturer of the system and the age of the system, as the default code changes frequently over time. The default settings for older alert systems allow you to completely reprogram if necessary.
Reset alarm system allows you to completely re-program your alarm system. You can also eliminate errors that may have occurred over the years. How you set the alarm by default depends on the type of alarm you are using.
Conclusion
Reset alarm systems may be relatively easy, but re-programming the whole panel is a complex process and only possible by a trained engineer on site. So, if you do not know the alarm system code start from the easiest ways, then if you did not find the code you inevitably should re-program the alarm system.
